Indirect Measurements; Transport - Hilti PD-E Mode D'emploi

5.12.3 Calibrate inclination sensor
1. Place the tool on a horizontal surface and press the "Measure" button.
2. Rotate the tool through 180° and press the "Measure" button.
◁ The inclination sensor is now calibrated.

5.13 Indirect measurements

5.13.1 Indirect horizontal distance measurement
▶ Aim the tool at the target point and press the "Measure" button.
◁ The distance and angle of inclination are measured and shown in the intermediate result line.
◁ The target distance is calculated immediately and shown in the result line.
5.13.2 Indirect vertical distance (2 angles, 2 distances)
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
5.13.3 Taking measurements on ceilings
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
5.13.4 Indirect vertical distance II (2 angles, 1 distance)
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
6 Care, transport and storage
6.1 Cleaning
▶ Do not touch the lens with the fingers.
▶ Clean the lens by blowing the dust off or by wiping with a clean, dry cloth.
▶ Do not use liquids other than pure alcohol or water.

6.2 Transport

Note
The batteries must be insulated or removed from the product before it is shipped or sent by mail.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting or shipping your equipment.
6.3 Storage and drying
▶ Do not put the product into storage when wet. Allow it to dry before putting it away.
▶ Observe the temperature limits given in the Technical Data section which are applicable to storage or
transport of the equipment.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
10