Taurus RCMB22 Mode D'emploi page 14

• Make sure that dust, dirt or other foreign objects do not
block the fan grill on the appliance.
• Never leave the appliance connected and unattended if
is not in use. This saves energy and prolongs the life of
the appliance.
• Do not use the appliance to dry pets or animals.
• Do not use the appliance to dry textiles of any kind.
• CAUTION: User can't sleep when appliance is under use;
there is a risk of injuries.
INSTALLATION
• Do not use this heater in the immediate surroundings of a
bath, a shower or a swimming pool.
• If the appliance is installed on a bathroom wall, it must be
positioned in such a way that the socket, power supply
cable, switches or other controls are not within the reach
a person in the bath, shower or at the wash-hand basin.
• If you use the appliance in a bathroom or similar place,
unplug the appliance from the mains when it is not in use,
even if it is only for a short while, as proximity to water
involves a risk, even if the appliance is disconnected.
• This appliance must be fixed into a wall. The minimum
distance between the floor and the lower part of the
appliance is 1,8m. (Fig.1).
• Do not cover or obstruct the sides of the appliance, leave
a minimum space of 25 cm around the appliance.
• Do not cover or obstruct any of the openings of the
appliance.
• The plug must be easily accessible so it can be
disconnected in an emergency.
ASSEMBLING TO THE WALL
• Mark on the wall where the holes should be made
(42.8 cm apart). (Fig. 1)
• Drill the holes and place the plugs.
• Fix the screws in the plugs, leaving a space of 5-7mm
between the wall and the screw heads.
• Fit the rear support holes of the appliance with the screws
fixed to the wall.
• Make sure that the device is not too loose, in which case
you will have to tighten the screws a little more and repeat
the operation.
• Make sure that the appliance is firmly fixed.
INSTRUCTIONS FOR USE
BEFORE USE
• Make sure that all product's packaging has been
removed.
• Please read carefully the "Safety advice and warnings"
booklet before first use
• Some parts of the appliance have been lightly greased.
Consequently, the first time the appliance is used a light
smoke may be detected. After a short time, this smoke
will disappear.
• To eliminate the smell given off by the appliance when
used for the first time, it is recommended to have it on at
full power for 15 minutes in a well-ventilated room.
• Prepare the appliance according to the function you wish
to use:
USE
• Connect the appliance to the mains.
• Turn the appliance on, by using the on/off switch (D).
Then start the device, by using the on/off button (9)(d)
• Select the desired mode. (7)(a)
• Select the desired level by pressing increase and
decrease buttons, or pressing repeatedly the heating
power button (b)
HEATER FUNCTION
• Select the heater mode. (7)(a)
• Select the desired level by pressing increase and
decrease buttons (6)(e) and (8)(g), or pressing repeatedly
the heating power button (b)
PROGRAMMING
CLOCK AND WEEKLY SETTING
• The appliance's operating time can be controlled.
• To program the operating time press the Timer Function
(5)-(f) during 3 seconds to enter "clock and day of the
week" menu. The screen displays "d".
• Press increase or decrease buttons to select the day.
1 Monday
2 Tuesday
3 Wednesday
4 Thursday
5 Friday
6 Saturday
7 Sunday
• Press the timer function button again to confirm day
setting and enter to hour setting. The screen displays "h".
• Press increase or decrease buttons to set the hour and
press again the timer function button to confirm and enter
to minute setting. The screen will display "n".