Publicité
Les langues disponibles
Les langues disponibles
MOUNTING ABRASIVES
These tools are equipped with an exclusive spindle lock feature that
makes it fast and easy to change abrasive accessories.
1) To loosen collet, press and keep holding the locking spindle button
down (4). It may be necessary to turn the spindle for the spindle
to engage. Loosen collet nut by turning it counterclockwise with
supplied 19 mm open-end spanner.
2) Slip point shaft into collet making sure that the shaft size matches
the collet opening. The tools are supplied with a 1/4" collet.
3) Secure mounted point by screwing back on spindle and turning collet
nut clockwise. Tighten firmly.
4) Keep accessory shaft overhang to a minimum by slipping it into the
collet as far as possible.
CARBON BRUSHES
This tool is equipped with self-disconnecting carbon brushes. When the
brushes have reached their minimum length, they automatically interrupt
the current flow and the tool stops.
Use only genuine WALTER carbon brushes. These brushes are specially
made for these tools; they will maintain their high performance standard
and ensure maximum life of the motor.
When the carbon brushes require replacement, it is recommended that
the tool be sent to a WALTER Factory Service Center or a WALTER
Authorized Service Center. Apart from changing the brushes, your power
tool will be cleaned, inspected and lubricated as required. If new parts
are necessary, only genuine WALTER replacement parts will be used.
PREVENTIVE MAINTENANCE
Your WALTER power tool should be properly maintained to insure
continued high performance. Use low pressure compressed air to blow
out dust from the motor through the vent openings.
Clean dust and dirt deposits from the exterior of the tool. Clean the
power cord to prevent deterioration from oil and grease and check for
possible damage.
Note: Damaged cord sets must be replaced. Refer to the Spare Parts
List for the order number.
DialSpeed
TM
EN
15
Publicité
