Philips QP6520 Mode D'emploi page 6

Problem
The
appliance
does not
work
anymore.
The
appliance
does not cut
hairs
anymore.
The
appliance
makes a
strange
noise.
The
appliance
does not
function
optimally
anymore.
Français (Canada)
Description générale
1 Lame
2 Glissière de libération de la lame
3 Système de verrouillage pour voyage
4 Pourcentage de niveau de la batterie
5 Symbole de charge
6 Afficheur numérique
7 Bouton de veille
8 Socle de charge
9 Petite fiche du socle de charge
10 Petite fiche
11 Bloc d'alimentation
12 Sabot de coupe de précision
13 Molette de réglage de la longueur de coupe
Non illustré : étui
Introduction
Félicitations pour votre achat et bienvenue dans
l'univers Philips! Pour profiter pleinement des
avantages de l'assistance Philips, enregistrez votre
produit à l'adresse www.philips.com/welcome.
Possible
cause
The
rechargeable
battery is
empty.
The blade is
blocked by
dirt.
Travel lock is
activated.
The blade is
placed on the
handle
incorrectly.
The blade is
damaged or
worn.
The blade is
damaged or
worn.
The blade is
placed on the
handle
incorrectly.
The blade is
blocked by
dirt.
The blade is
blocked by
dirt.
The blade is
subject to
wear and
therefore its
performance
decreases
over time.
The blade is a
delicate part
of the
appliance
and can
easily be
damaged. If
the blade is
damaged, it
may not
function
optimally
anymore.
Solution
Charge the
appliance (see
chapter 'Charging').
During charging,
the battery charge
indicator flashes
white. If the battery
charge indicator
does not flash,
check whether
there is a power
failure or if the wall
socket is live. If
there is no power
failure and the wall
socket is live but
the battery charge
indicator still does
not flash, take the
appliance to your
dealer or a Philips
service center.
Switch on the
appliance and
rinse the blade
under the tap with
warm water.
Hold the blade in a
cup with warm
water (60°C and
not hotter) for
approx. 30
seconds.
Press the on/off
button for 3
seconds to
deactivate travel
lock.While you
deactivate the
travel lock, the
display counts
down. Then the
travel lock symbol
lights up and
switches off.The
appliance is now
ready for use again.
Push the blade
onto the appliance
until you hear a
click.
Replace the blade
with a new one.
See chapter
'Replacement'.
Replace the blade
with a new one.
See chapter
'Replacement'.
Remove and
reattach the blade.
Push it onto the
appliance until you
hear a click.
Remove the blade
and clean the
blade thoroughly.
Remove the blade
and clean the
blade thoroughly.
Replace the blade
with a new one.
See chapter
'Replacement'.
Replace the blade
with a new one.
See chapter
'Replacement'.