Bobbin Winding; Threading The Upper Thread - Euro-Pro Operating Dressmaker PLUS 970C Manuel D'instruction

3. Bobbin winding

1. Place a spool of thread on the long spool pin.
2. Insert the bobbin winding spindle into the central hole of the handwheel and
push an empty bobbin onto the spindle.
3. Wind the thread clockwise around the bobbin several times.
4. Place your index finger gently underneath the thread between the spool of
thread and the bobbin as shown in the illustration below.
5. Press down on the On/Off button to start winding.
6. Stop the sewing machine after the correct amount of thread is wound around
the bobbin.
7. Take the bobbin off the spindle and cut the thread.
5

4. Threading the upper thread

1. Place the upper bobbin or large spool of thread on the spool pin with the thread
unwinding in a counter clockwise direction.
2. Pull the thread to the left and pass through the first thread guide (1).
3. Pass the thread between the two discs of the tension dial (2).
4. Thread it through the hole in the take-up lever (3) and then down through the
second thread guide (4) and then through the needle bar thread guide (5).
5. Pass the thread through the eye of the needle going from left to right (6). A
needle threader is supplied with your machine to help you thread the eye of the
needle. To use the needle threader, pass it through the eye of the needle
going from right to left, insert the thread in the threader and gently pull the
threader to the right.
6