Installing The Grille - Mitsubishi Electric City Multi PLFY-P NBMU-E Série Manuel D'installation

5. Installing the grille

Fig. 5-1
Fig. 5-2
Fig. 5-3
Fig. 5-4
4-directional
1 pattern:
Initial setting
Blowout
direction
patterns
2-directional
6 patterns:
2 air outlet fully closed
Blowout
direction
patterns
Table 1
Fig. 5-5
12
5.1. Checking the contents (Fig. 5-1)
• This kit contains this manual and the following parts.
5.2. Preparing to attach the grille (Fig. 5-2)
• With the gauge
• Make sure that the opening in the ceiling is within the following tolerances:
• Make sure that A is performed within 17-22 mm, 11/16-7/8 inch. Damage could
5.2.1. Removing the intake grille (Fig. 5-3)
• Slide the levers in the direction indicated by the arrow
• Unlatch the hook that secures the grille.
• With the intake grille in the "open" position, remove the hinge of the intake grille
5.2.2. Removing the corner panel (Fig. 5-4)
• Remove the screw from the corner of the corner panel. Slide the corner panel as
3-directional
5.3. Selection of the air outlets
4 patterns:
For this grille the discharge direction is available in 11 patterns. Also, by setting the
1 air outlet fully closed
remote controller to the appropriate settings, you can adjust the air-fl ow and speed.
Select the required settings from the Table 1 according to the location in which you
want to install the unit.
1) Decide on the discharge direction pattern.
2) Be sure to set the remote contoller to the appropriate settings, according to the
Note:
For 3 and 2-directional, please use the air outlet shutter plate (option).
5.4. Installing the grille
5.4.1. Preparations (Fig. 5-5)
• Install the two enclosed screws with washer
(inch)
Main unit
Screw with
captive washer
Accessory name
Grille
1
Screw with captive washer
2
Gauge
3
Fastener
4
Screw
5
Screw
6
supplied with this kit, adjust and check the positioning of the
3
unit relative to the ceiling. If the unit is not properly positioned relative to the ceil-
ing, it may allow air leaks or cause condensation to collect.
860 × 860 - 910 × 910, 33-7/8 × 33-7/8 to 35-13/16 × 35-13/16 inch
result by failing to adhere to this range.
Main unit
A
Ceiling
B
Gauge (inserted into the unit)
C 3
Ceiling opening dimensions
D
* Do not unlatch the hook for the intake grille.
from the grille as indicated by the arrow
indicated by the arrow to remove the corner panel.
1
[Fig.5-3, 5-4]
Intake grille
A
Grille
B
Intake grille levers
C
Grille hook
D
Hole for the grille's hook
E
Corner panel
F
Screw
G
Detail
H
number of air outlets and the height of the ceiling on which the unit will be in-
stalled.
drain pipe area and at the opposite corner) as shown in the diagram.
Q'ty Remark
1 950 × 950 (mm), 37-3/8 × 37-3/8 (inch)
4 M5 × 0.8 × 25
1 (Divided into four parts)
3
4 4 × 8
1 4 × 12
to open the intake grille.
1
.
2
in the main unit (at the corner
2