Acksys RailTrack Série Guide D'installation Rapide page 21

None of the LED indicators turns ON
•
Verify the power supply (voltage, cabling).
The relevant LAN led indicator stays OFF
•
Check that the remote device is turned ON.
•
Check the Ethernet plugs on both sides.
•
Try to connect to another device.
•
Use the provided ACKSYS M12/RJ45 cable to connect the device.
The Wi-Fi link does not come up
•
Make sure that the Wireless parameters of the Client (case sensitive
SSID, 802.11 mode, radio channel and security) match those of the AP.
•
Check the radio conditions: distance between devices, placement of
antennas, interferences and obstacles to radio waves propagation.
•
Try with all securities and encryption settings temporarily disabled.
•
Try using the product with factory settings as shown in the "Quickly
evaluate..." section.
•
Try another radio channel.
How to restore factory settings
•
If the built-in web-based interface is reachable, you can use your
browser to restore factory settings.
•
Else, power up the unit, wait for the red "Diag" LED to turn green, then
hold down the reset button (for at least 2 seconds) until "Diag" goes red.
Then release it and wait for the Diag LED to turn green again, meaning
that the product rebooted with its factory settings.
Reset button is attainable by unscrewing the black protective vent with an
16mm spanner.
Notice: when the product is powered on, please don't touch any elements but
the reset button. Take all necessary precautions in order to avoid electric
shock and electrostatic discharge.
Tighten the vent at 0.8Nm ± 10% to provide water tightness.
TROUBLESHOOTING
RESET
-5-