F-One PLATINIUM 3 BINDINGS Mode D'emploi page 6

SETTING UP THE FOOTSTRAPS :
To identify the left footstrap from the right one, check the indication written on the label near the tightening
Velcro strap. When setting up the footstrap, this label should be located on the inner side of your foot.
LEFT
Insert the straplock in the strap and pass the Velcro
in the appropriate hole.
1
Place the first velcro strap on the strap.
3
www.f-onekites.com
All manuals and user guides at all-guides.com
RIGHT
Set the height of the footstrap for your size by
adjusting the position over the straplock.
2
Fold the second velcro strap on top of the first one.
4
ADJUST YOUR STANCE :
All F-ONE Twin-Tips offer three different
feet spacings (stance).
ADJUST THE ANGLE OF THE PADS :
You can adjust the orientation of the
plates on the board to achieve the
angle you feel most comfortable with
when riding. F-ONE recommends an
angle of 12°.
CENTERING YOUR FEET :
You can adjust the position of your
plates to keep them centered on the
board (especially for people using the
Small or Large setups). Simply move
the plates forward or backward while
maintaining the angle chosen.
Once you have chosen the angle and
centering you need, you can place and
tighten the screws with their washers.
Caution: make sure the flat side of the
washers is always located towards the
footstrap. The notch located on the
opposite side will let you see the angle
engraved onto the plate.
TRAVELLING TRICK :
When taking off the pads/plates from
your board, you can fit the screws and
washers in the two holes located un-
der the pad for this purpose. No more
time wasted looking around for them.
HANDLE
SETTING UP THE HANDLE :
Place the handle above the two inserts
located at the center of the board and
tighten the screws down. The screws
and washers are pre-fitted into the
handle but they can be taken away
by gently forcing them out if required.
- 10 -
www.f-onekites.com
EN
- 11 -