F-One PLATINIUM 3 BINDINGS Mode D'emploi page 5

PLATINIUM BINDINGS
3
CAUTION: Read attentively all the content of the user manual before assembling the straplocks and plates.
HOW TO ASSEMBLE YOUR STRAPLOCKS AND PLATES?
Before assembling the parts together, you need
to identify the plates. Place them on the board
with the left plate on the left foot area and the right
plate and right foot area. The identification is lo-
cated on the inward side of the pad.
LEFT STRAPLOCK
For each plate, take a Left straplock and a Right straplock. The indication is located at the top of the straplock.
straplock
Left
straplock
Left pad
Left
foot inserts
Make sure you have clearly identified both the left and right side of the boards by checking the inserts
ADJUST THE STRAPLOCKS TO THE WIDTH OF YOUR FEET :
Each straplock can be fitted in two different ways:
NARROW
•
To insert your straplock into the narrow position, place the "Narrow foot" indication towards the exterior of the plate.
• To insert your straplock into the wide position, place the "Wide foot" indication towards the exterior of the pad/plate.
www.f-onekites.com
All manuals and user guides at all-guides.com
RIGHT STRAPLOCK
Right Left
straplock
Right
straplock
Right
foot inserts
WIDE
You can therefore assemble the straplocks with three different setups depending on the
width of your feet:
SLIM
Slim feet setup :
Assemble both straplocks in
the NARROW position.
ADJUST THE STRAPLOCKS TO THE LENGTH OF YOUR FEET :
The plate provides three positions to adjust the location of the straplocks to the length
of your feet :
S (small), M (medium) and L (long). This tuning makes sure your toes are always located on the dedicated
spot on the pad. (see picture 3)
Small position : insert the straplocks with the
bottom fitting into the three slots located at the top
Right pad
of the tuning rail.
Medium position : insert the straplocks with the
bottom fitting into the three slots located at the
center of the tuning rail.
Long position : insert the straplocks with the
bottom fitting into the three slots located at the
bottom of the tuning rail.
INSERTING YOUR STRAPLOCKS :
To fit the straplocks onto the pad/plate, insert the straplock into the tuning rail with the right setup depen-
ding on your feet width and length. Once the straplock is positioned in the correct slots, pull with your hand
on the top straplock while maintaining an angle. You can pull back and forth to achieve this more easily.
- 8 -
www.f-onekites.com
MEDIUM
Medium feet setup : Large feet setup :
Assemble the inner straplock in the Assemble both straplocks in
NARROW position and the outer the WIDE the position.
straplock in the Wide position.
70°
EN
LARGE
70°
- 9 -