Electrical Requirements; Set Up And Preparation For Operation - elem garden technic FB1500-5TEG52 Mode D'emploi

ELECTRICAL REQUIREMENTS

Connect the main leads to a standard 230V+10% (50Hz+1Hz) electrical supply which
has protection devices of under-voltage, over-voltage, over-current as well as a
residual current device (RCD) which maximum residual current rated at 0.03A.

SET UP AND PREPARATION FOR OPERATION

5. Bolt the Support Leg to the Log Splitter, lift the log splitter by the handles at both
ends and place it on a 60 – 75cm high, stable, flat and level work surface.
6. Familiarize yourself with the controls and features of this log splitter in the
illustrations.
1. Log Pusher
2. Work Table
3. Wedge
4. Lift Handle
5. Support Leg
6. Log Retaining Plates
7. Switch
8. Motor
9. Pushbutton Box
10. Wheels for Minor Moving
ONLY.
11. Hydraulic Control Lever
12. Control Lever Guard
13. Bleed Screw
14. Oil Drain Bolt w/ Dipstick
33