Changing The Motor Protection Filter; Transport - Husqvarna S 11 Notice D'utilisation

▷ Dispose of gathered material in accordance with legal require-
ments.
7.3 Insert fleece filter bag
Only use fleece filter bags for dry vacuum cleaning.
▷ Slide the flange completely over the intake socket.
Operating the rotary slide
▷ Turn the red rotary slide inside to position CLOSE to the stop
on the marker ▲.
7.4 Insert PE emptying and disposal bag*
Only the vacuum cleaners class L, M and H with special
containers and rotary slider in the suction aperture of types
IS/ISC L, M, H and H-ASBEST are suitable for the use of PE
Emptying and disposal bags.
Operating the rotary slide
▷ Turn the red rotary slide inside to position OPEN to the stop
on the marker ▲.
▷ Slide the flange completely over the intake socket.
▷ Place the upper bag opening over the container rim.
* depending on model
NOTE
NOTE
NOTE
NOTE
8 Changing the filter
8.1 Changing the folded filter cartridges
▷ Clean the filter cartridges before changing them.
▷ Turn the lock on the latch through 90° in a counter-clockwise
direction with a coin or similar object and push the latch to the
rear.
▷ Fold up the cover.
▷ Immediately isolate the folded filter cartridges that you have
removed in a dust-tight plastic bag and dispose of properly in
accordance with the requirements.
▷ Insert new folded filter cartridges.
▷ Lift the locking bracket up, fold down the cover and click in place
with light pressure.
9

Changing the motor protection filter

If motor protection filter is contaminated, this indicates defective
filter cartridges.
▷ Replace folded filter cartridges.
▷ Replace motor protection filter or wash the motor protection
filter under flowing water, dry and re-insert.
10

Transport

▷ Remove suction hose.
▷ Close off intake socket with cap.
▷ Securely fix the motor head to the container.
▷ Close the side latches.
▷ Place the accessories in a suitable plastic bag and seal the plas-
tic bag or place it in the tool storage compartment.
▷ Put the suction hose ends together so that no dirt particles leak
out.
▷ Place the hose around the vacuum cleaner and clamp onto the
handle.
11 Maintenance
Switch off the vacuum cleaner and pull out the mains plug before
carrying out any maintenance work.
For maintenance by the user, the vacuum cleaner must be
- dismantled,
- cleanded and
- maintained,
as far as possible without creating any danger to the maintenance
personnel or other.
NOTE
NOTE
en- 9