Filter Change - Husqvarna T 4000 Manuel D'utilisation

Maintenance schedule T-Line Dust
Extractor
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Maintenance
Look for signs of wear,
damage or loose connec-
tions of the controls before
the unit is connected.
Do a check that the Longo-
pac is correct.
Do a check of the filter
cleaning mechanism.
Do a check of the dust
hose and the connections.
Do a check of the wheels.
Look for damage and bad
connections.
Clean the pre-filter.
Replace the pre-filter.
Replace the Hepa filter
To clean the dust extractor
It is important to clean the dust extractor to prevent
circulation of dangerous dust. Always clean the dust
extractor before it is moved from the work area.
WARNING:
its OFF position and disconnect the cord
from the wall outlet before you clean or do
maintenance to the product.
• All equipment once used must be regarded as
contaminated and be treated thereafter.
• All parts that are contaminated after service work
must be disposed in a correct procedure in plastic
bags. Refer to local regulations.
• Use correct personal equipment when you clean the
Personal protective equipment on
product. Refer to
page 7 .
• Clean the external surface with a moist cloth.
• Clean the filters and the dust extractor in applicable
area.
• Vacuum the pre-filter from the inside. Always use
dust extractors with Hepa filter and a soft brush to
not damage the filter.
• Do not use water on electrical components.
10
Before each Daily
use
X
X
X
X
Turn the motor switch to
Weekly When suc-
tion is low
X
X
X
X
• Do not clean the dust extractor with high pressure
(air or water).
• Do not put tools on the surface of the filter, it can
cause damage to the filter.
• Do not make a hole in the Hepa filter, it can cause a
health risk.

Filter change

WARNING:
equipment, refer to
equipment on page 7 , during filter change.
Dust can come out during filter change.
WARNING:
switch in the Off position and disconnect the
cord from the wall outlet during filter change.
WARNING:
fasteners can cause damage to the operator
when assemble the product.
To clean the pre filter
The filter must be cleaned from time to time. This
must be done before changing the plastic bag collection
6 months or 12 months
1000h or 2000h
X
X
Use personal safety
Personal protective
Always turn the motor
Be careful, the toggle
877 - 006 - 03.02.2022