Ac Current Measurement - Ht Instruments Ht100 Manuel D'utilisation

4.3.5 AC Current measurement

Make sure that all the test leads are disconnected from the meter terminals
for current measurement.
1. Put the conductor to be tested inside to the "open" clamp jaw (see Fig. 7) considering
the alignment marks (see § 4.1.2). The current value is shown at display.
2. "OL" message is shown at display the current under test is over the maximum value
that the instrument is able to measure
3. For HOLD function please refer to § 4.2.1
As the clamp has internal filter it could happen that the meter takes few
seconds to reach 0 value on the display. This is not a defect, indeed the
user can proceed with a test as the temporary displayed value will not be
added to the measured value.
Fig. 7: Taking AC current measurement
EN - 12
CAUTION
CAUTION
HT100