Publicité
Les langues disponibles
Les langues disponibles
▪
Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Energy saving tips
▪
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
▪
Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.
▪
Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
▪
Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.
▪
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifetime of these
LEDs is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your appliance,
the LEDs were defective, please contact your after-sales service for
any intervention.
Door reversal instructions
If you need to mount the refrigerator door the other way around, it is recommended that you
call your authorized service agent to do this reversal, or ask a technician.
Before reversing the opening direction of the door, you must make sure that the appliance is
unplugged and empty. It is recommended to use a screwdriver cruciform and a key (not
supplied).
The side to which the refrigerator door opens can be altered on the right side to the left, if the
place of installation so requires.
1.
Remove the two lids (1), remove the two screws (2) of the top panel.
2.
Remove the two screws at the back of the top panel. Remove the top cover of the
fridge.
3.
Remove the two screws (3) securing the right upper hinge (5) to the structure and
remove it (4).
4.
Lift the door and place it on a padded surface to prevent scratching.
5.
Remove the two screws (5) securing the lower hinge (6) and remove.
6.
Remove the front foot and pass to the right side.
7.
Before inserting the lower hinge remove the plug (7) and reverse the direction of the
lower hinge. Then install the lower hinge on the left side of the lower structure with the
screws.
8.
Fit the plug in the lower hinge.
33
Publicité
