Ryobi RP4290 Manuel D'utilisation page 12

GB
FR DE ES
OPERATION
CHIME/ALARM MODE OPERATION
When the device is in Chime mode:
Once armed, an audible tone sounds as soon as someone enters the sensor's line
■
of sight. The alert will continue every 2 seconds until the person leaves the area.
Once the sensor no longer detects motion, it will reset back into the armed state.
When the device is in Alarm mode:
Once armed, the alarm sequence will begin after 2 seconds of the sensor detecting
■
continuous motion. This helps to avoid nuisance alarms such as animals entering
and leaving the area quickly.
After 2 seconds of continuous motion, the LED will blink for 13 seconds to allow the
■
operator time to disarm the device before the alarm is triggered.
Once the alarm is triggered, it will sound for 2 minutes. If motion is still detected
■
after that time, the alarm will continue to sound for another 2 minutes. If no motion
is detected, the alarm will reset back into the armed state.
IT NL PT DK SE FI NO RU PL CZ
English
MAINTENANCE
WARNING
When servicing, use only identical RYOBI replacement parts. Use of any
other parts may create a hazard or cause product damage.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not attempt to modify this tool or create accessories not recommended
for use with this tool. Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious personal injury.
7
HU RO LV LT EE HR SI SK GR TR