GardiPool Rectoo Notice De Montage page 56

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

manual - RECTOO
Manual
ConTEnT
1. Introduction
2. Assembly
2.1 Earth works
3. options
6.4 Summer / Winter cover
56
1. Introduction
Congratulations on purchasing your
Gardipool swimming pool. Your pool is
manufactured from quality North-Euro-
pean pressure impregnated pinewood.
This treatment offers protection against
rotting and keeps the wood mould-free.
The top border is either in North-Euro-
pean pine or in exotic hardwood, which is
by nature very resistant.
Enclosed, you will find the instructions
for the do-it-yourself assembly of your
Gardipool.
It is advisable that you read the complete
instructions before you start with the
assembly of the pool.
Always follow all safety regulations.
Should you encounter any problems du-
ring the construction, please contact your
Gardipool sales representative, who will
assist you with help and advice.
Without supervision,
your child is in danger.
2. Assembly
2.1 Earth works
The pool should preferably be positioned
in a sunny place, away from any trees
whose leaves could fall into the pool.
It is extremely important that your pool
be assembled on a stable foundation.
You need to construct a flat armed
uncracked concrete floor with integrated
metal profiles and a metal mesh as
specified on the drawings herewith,
1) A minimum 18 cm thick concrete floor
C25/30 of which min. 6 cm has to be
installed above the metal profiles.
The bottom side of the concrete floor
has to be the same as the metal
profile's bottom side.
2) The mesh 150x150x6x6 has to be
placed on top and diagonally on the
horizontal metal profiles.
Apply a layer of plastic foil underneath
the concrete slab to obtain an optimal
drying.
In (half) sunken pools, you must cover
the underground wooden structure with
a protective felt layer to ensure that
the structure never touches the ground
directly. This forms the division between
the structure and the stabilised sand
with which you filled the gap after the
assembly of the pool, to ensure
adequate drainage of the ground water
and rainwater. You must also ensure that
the ground and rain water around the
pool is discharged effectively by means
of an adapted drainage system.
Make sure that the ground or water
never touches the wooden structure
directly. Provide an adapted felt layer
around the pool as protection.
The finishing around the pool can be
chosen according to your personal taste:
wooden terrace, planks, paving stones,
tiles, or lawn (only a top layer of 10 cm
(4 inches).

Publicité

Table des Matières
loading

Table des Matières