Troubleshooting - Haier HF50CW20W Manuel D'utilisation Et D'installation

TROUBLESHOOTING

Problem Possible Causes
Freezer does not Temperature control set to OFF
operate position.
Freezer is unplugged.
The fuse is blown/circuit breaker is
tripped.
Freezer starts/stops Lid left open.
too frequently
Too frequent or too long lid
openings.
Temperature control set too cold.
Freezer operates too Lid left open.
long
Too frequent or too long lid
openings.
Temperature control set too cold.
Inadequate air circulation space
around cabinet.
Room or outside weather is hot.
Freezer has been disconnected
recently for a period of time.
Large amounts of warm or hot food
have been stored recently.
Noisy operation or Floor may be weak, causing freezer
cabinet vibrates to vibrate when compressor is on.
Cabinet is not positioned solidly on
floor.
Freezer is touching the wall.
Freezer temperature Lid left open.
too warm
Too frequent or too long lid
openings.
Temperature control is set too
warm.
Large amounts of water or hot food
may have been stored recently.
Freezer has been disconnected
recently.
Foods defrosting Temperature control set to OFF
position.
Freezer is unplugged.
The fuse is blown/circuit breaker is
tripped.
Lid left open.
Too frequent or too long lid
openings.
Freezer temperature Temperature control set too cold.
too cold
49-1000530 Rev. 0
What To Do
Turn the temperature control to a setting between 1 and 7.
Push the plug completely into the outlet.
Replace fuse or reset the breaker.
Check to see if package is holding lid open.
Open the lid less often.
See About the operation of your freezer.
Check to see if package is holding lid open.
Open the lid less often.
See About the operation of your freezer.
See Preparing to install the freezer.
It's normal for the freezer to work harder under these
conditions.
It takes 6-8 hours for the freezer to cool down completely.
Warm food will cause the freezer to run more until the desired
temperature is reached
Check to make sure freezer is located on solid floor and use
shims, as needed, to level the unit.
See Preparing to install the freezer. Use shims, as needed, to
level the unit.
Level freezer or move slightly. See Level Freezer.
Check to see if package is holding lid open.
Open the lid less often.
Turn control to a colder setting. Allow several hours for the
temperature to stabilize.
Wait until the freezer has had a chance to reach its selected
temperature.
Freezer requires 6-8 hours to cool down completely.
Turn the temperature control to a setting between 1 and 7.
Push the plug completely into the outlet.
Replace fuse or reset the breaker.
Check to see if package is holding lid open.
Open the lid less often.
See About the operation of your freezer.
11