Rane RAD26 Guide D'utilisation page 33

Parameter
Auxiliary Input (3.5 mm Stereo TRS Switching Connector)
Gain
Max. Input Level
Dynamic Range (input)
Frequency Response
THD + Noise
Balanced Line-level Output Specs (Active Balanced) (2.54 mm Euroblock Terminal)
Output Impedance
Max. Output Level
Dynamic Range
Frequency Response
THD + Noise
Headphone Output (3.5 mm Stereo TRS Switching Connector)
Maximum Output
Minimum Load
Amplifier Outputs (Full Bridge Class D Power Amplifier)
Max. Output Power
(Dual Mode)
Max. Output Power
(Single Mode)
Dynamic Range
Frequency Response
THD + Noise
Specification Limit Units Conditions/Comments
0 to 20 typ.
12 max.
101 typ.
20 to 20k typ.
@ 1 kHz, 20 kHz BW, Rs = 150 Ω, Output = -6 dBFS, Gain = 0 dB
0.008% typ.
200 1%
14 min.
104 typ.
20 to 20k typ.
0.01% typ. @ 1 kHz, 20 kHz BW, Rs = 150 Ω, Output = +4 dBu, RAD26 Input to Output
130 typ.
32
4 max.
8 max.
99 typ.
20 to 20k typ.
@ 1 kHz, 20 kHz BW, Rload = 8 Ω, Output = 1 W
.02% typ.
dB In 1 dB Steps
dBu 10 dBV
dB re: 0 dBFS, 20 kHz BW, A-weighted
dB +0, -0.5 dB, at all Gain settings
Ω
Each Leg
dBu < 1% THD, Load = 10 kΩ
dB re: 0 dBFS, 20 kHz BW, A-weighted
dB +0, -0.5 dB, at all Gain settings
mW per channel, Rload = 32 Ω
Ω
W 8 Ω load, <0.1% THD, both channels
8 Ω load, <0.1% THD, Ch.1 only, Ch. 2 disabled
W
dB re: 0 dBFS, 20 kHz BW, A-weighted, Dual 4W Mode
Hz +0, -0.5 dB, at all Gain settings
33