Device-Specific Safety Instructions; Your Product At A Glance - Lux Tools D-Rfg-10 Notice Originale

GB
• Unrestrained compressed air hoses as
well as the resultant fragments or dust
being blown around can cause injuries.
Pull all hose clamps tight before com-
mencing work and replace damaged sup-
ply lines.
• Blow through or clean connections before
using for the first time. Soiling can impair
the function and and safety of the product.
• Disconnect the product from the com-
pressed air supply during breaks in work,
prolonged periods of non-use or taking
out of operation.
• The product may only be connected to
lines that have a protection mechanism to
prevent the maximum permissible pres-
sure from being exceeded by more than
10%. This can be achieved, for example,
by a pressure regulating valve with a
downstream or built-in pressure limiting
valve being fitted into the compressed air
line.
• Only operate the product at the pressure
required for the operation concerned, in
order to prevent unnecessarily high noise
levels, excessive wear and the resultant
malfunctions.
• Compressed air can be dangerous if the
operator is unsure how it should be han-
dled. Assembly, commissioning and
maintenance is reserved for trained and
experienced persons.
• Do not direct compressed air at yourself
or at others in order to clean clothing and
footwear.
• Never blast objects that contain hazard-
ous substances (e.g. asbestos).
• Never use solvent-based liquids, acetone,
undiluted acids or solvents as cleaning
agents! A spray mist from these sub-
stances is highly hazardous to health and
possibly explosive.
• Live components in the work area must be
protected from dirt and dust particles
being blown around.
• Only use compressed air. Never use air
containing chemicals, synthetic oils
(organic solvents), salts or corrosive gas,
as it can cause damage and malfunctions.
• Use only lubricants recommended by the
manufacturer.
• Compressed air products are not earthed.
Proceed with caution when coming into
contact with power sources.
18
• Always attach protective caps when
transporting or storing products and
accessories.
Maintenance
• Interrupt, vent and depressurise all con-
nections before commencing any work on
the product.
• Only those maintenance and fault elimi-
nation tasks described here may be car-
ried out. Any other tasks must be com-
pleted by a specialist.
• Only use original replacement parts. Only
these replacement parts are designed
and suitable for the device. Other replace-
ment parts will not only lead to an invalida-
tion of the warranty, they may also endan-
ger you and your environment.

Device-specific safety instructions

• Make sure that the work area is well ven-
tilated.
• Make sure there is adequate lighting
when working with the product.
• Always maintain a firm stance and have a
natural posture when working.
• The on-off switch must be released if the
power supply fails, in order to prevent an
abrupt start-up when the power supply is
restored.
• Never insert tips and/or metallic objects
into the product.
• The container may burst, when filled with
the pressure exceeding the maximum
limit allowed by the manufacturer, this in
return may result in severe injuries and
death!
• Symbols appearing on your product may
not be removed or covered. Information
notices on the product that are no longer
legible must be replaced immediately.
Read and observe the operating in-
structions before commissioning.
Wear protective goggles.

Your product at a glance

Note: The actual appearance of your
device may differ from the illustra-
tions.
► P. 3, fig. 1
1. Hose
2. Pressure gauge
3. Trigger
4. Hose connection