Product Information; Concerns On Installation; Installation With Base - Graco Ascent Manuel D'utilisation

NEVER use ropes or any other
substitutes to secure enhanced
child restraint in vehicle or to
secure child into enhanced child
restraint.
Consult the distributor for issues
concerning maintenance, repair
and part replacement.
Remove this enhanced child
restraint from the vehicle seat
when it is not in use for a long
period of time.
The parts of this enhanced child
restraint should not be lubricated
in any way.
Always secure child in enhanced
child restraint, even on short trips,
as this is when most accidents
occur.
DO NOT put anything other
than the recommended inner
cushions in this enhanced child
restraint.
Product
Information
"i-Size" (Integral Universal ISOFIX
Enhanced Child Restraint
13
Systems) is a category of Enhanced
Child Restraint System for use in all
i-Size seating position of a vehicle.
1.
This is an "i-Size" Enhanced
Child Restraint System. It is
approved according to UN
Regulation No.129, for use
in, i-Size compatible vehicle
seating positions as indicated
by vehicle manufacturers in
the vehicle users' manual.
2.
If in doubt, consult either
the Enhanced Child Restraint
System manufacturer or the
retailer.
Concerns on
Installation
1 3
See images -
1
DO NOT install this enhanced
child restraint on vehicle seats
that face sideways or rearward
with respect to the moving
direction of the vehicle.
It is recommended to install
this enhanced child restraint
on the rear vehicle seat.
DO NOT install this enhanced
child restraint on vehicle seats
movable during installation.
2
DO NOT place rear-facing
enhanced child restraint
on front seat with air bag,
because death or serious
injury may occur. Please
reference vehicle owner' s
manual for more information.
3
This seat used with the Base is
suitable for vehicle seats with
i-Size ISOFIX anchor points.
Installation
with base
4 14
See images -
4
Fit the ISOFIX guides with the
ISOFIX anchor points.
The ISOFIX guides can protect
the surface of the vehicle seat
from being torn. They can also
guide the ISOFIX connectors.
5
Unfold the load leg from
storage compartment.
6
Line up the ISOFIX
connectors with the ISOFIX
guides, and then click both
ISOFIX connectors into the
ISOFIX anchor points.
7
Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX
anchor points. There should
be two audible clicks and the
colors of the indicators on
the both ISOFIX connectors
should be completely green.
Check to make sure the
base is securely installed by
pulling on the both ISOFIX
connectors.
8
After placing the base on the
vehicle seat, extend the load
leg to floor. When the load
leg indicator shows green, it
means it is installed correctly.
When the load leg indicator
shows red, it means the load
leg is in the wrong position.
14