FS S5500-48T6SP-R Guide De Démarrage Rapide page 10

Con guring the Switch Using the Console Port
Step 1: Connect a computer to the switch's console port with the supplied console cable.
Step 2: Start the terminal simulation software, such as the HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: Baud rate to 115200, Data bits to 8, Stop
bits to 1, no Sum check bit, and no Tra c control.
Step 4: After setting the parameters, click Connect to enter.
CAUTION: Be sure to save settings before exiting the software.
Troubleshooting
Power LEDs Working Abnormally
1. Check the power cable connections at the switch and the power outlet, and check
whether the power switch is on.
2. Make sure that all cables are used correctly and comply with the Ethernet speci cations.
HyperTerminal Displaying Abnormally
1. Make sure the power supply is normal and the console cable is properly connected.
2. Check whether the console cable is the right type.
3. Check whether the control cable driver is properly installed on the computer.
4. Ensure that the parameters of the HyperTerminal are correct.
Accessing the Web-Based Con guration Page Unsuccessfully
1. Check every port and LED on the switch and make sure the Ethernet cable is connected
properly.
2. Try another port on the switch and make sure the Ethernet cable is suitable and works
normally.
3. Power o the switch for a while, then power it on again.
4. Make sure the IP address of your PC is set within the subnet of the switch.
5. If you still cannot access the con guration page, please restore the switch to its factory
defaults.
Then the IP address of your PC should be set as 192.168.1.x ("x" is any number from 2 to
254) and Subnet Mask as 255.255.255.0.
9