Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Power Dome LT by Wagan Tech
Charging The Power Dome LT At Home With AC Power
•
Completely charge your Jumpstart before using for the first time.
•
Before recharging from an AC outlet, be sure the source voltage is correct. (i.e.110
volts or 20 volts)
•
Use only the chargers provided with unit.
•
Keep the Master on/off safety switch in the OFF position while charging.
•
Plug the AC charging cord into any standard wall outlet and the other end into the
AC/DC charging jack.
•
Full charge takes approximately 26–28 hours
•
Do not exceed recommended charging time 0 hours
Charging The Power Dome LT In Your Vehicle With DC Power
•
Keep the Master on/off safety switch in the OFF position while charging.
•
Plug the DC charging cord into any 12 volt (cigarette lighter) outlet and the other
end into the AC/DC charging jack.
•
Full charge takes approximately 6–8 hours
•
Do not exceed recommended charging time — initial charge 10 hours
Using The Air Compressor
•
Open the compartment door on the side of the Power Dome LT and pull out the air
hose.
•
Make sure nozzle lever is in the UP position.
•
Attach the valve adapter to the valve stem of the tire or other inflatable and push
the valve adapter lever down to lock into place.
•
Turn the Master on/off safety switch to the ON position.
•
Toggle the compressor switch on the front panel to the ON position.
•
Monitor the pressure gauge while inflating.
•
When appropriate pressure has been reached, turn the compressor off and discon-
nect the hose.
Using The 12 Volt DC Power Port
•
Remove the protective cover to one of the two DC 12V Socket plugs.
•
Plug in your 12 Volt accessory.
•
Turn the Master on/off safety switch to the ON position.
4
R
www.wagan.com
Publicité
Table des Matières
