Thermador T24UW820LS Guide D'installation page 17

1. Install the custom handle of your preference on the overlay frame before installing the frame on
the door.
Every custom handle is different and it is the responsibility of the customer to make the
*
necessary adjustments to place the handle on the overlay frame.
The screws used to affix the custom handle to the frame must be flat and flush with the surface of
the frame; if the screws are not flat, then consider making a recession on the overlay, enough to
hide the head of the screw below the surface of the overlay, otherwise the screws will interfere
with the correct placement of the overlay on the door.
2. Locate and identify every pair of holes on the overlay frame corresponding with the holes on the
door. Every hole must be aligned to screw and fasten the overlay to the door.
A
B
C
D
*
Install custom
handle first.
Overlay Frame with
Door
custom handle
Flat screw flush with surface
Overlay Frame with
Door
custom handle
Round head screw hidden in a
recession on the overlay.
A
B
C
D
Page | 17