Renkforce SA-101U Mode D'emploi page 28

(1) POWER switch
The mixer is switched on or off using this switch.
In the ON position, the mixer is switched on. When the device is switched on, the green power LED above
the MASTER LEVEL indicator (4) lights up.
(2) MIC microphone channel
Here, the main microphone is connected and the main microphone channel is controlled.
MIC connection
MIC LEVEL control
Controls HI, MID, and LOW
(3) Channels CH-1 to CH-4
Here, the four input channels are controlled.
Input selection switches LINE/
PHONO, LINE/USB, or LINE/
MIC
TRIM control
Controls HI, MID, and LOW
Level indicator
(4) MASTER LEVEL indicator
Indication of the master channel output level
(5) TALKOVER switch
When the switch is pressed in, the volume of all channels except for the microphone channel is reduced
to allow announcements by the DJ.
(6) HEADPHONES CUE switches
These switches are used to determine what channels are played on the headphone channel.
28
connection for the main microphone
microphone volume settings
adjustment of sound characteristics
(HI = high frequency range, MID = middle frequency range, LOW = low
frequency range)
selection of devices connected to INPUTS 18, 19, and 20
adjustment of input sensitivity of the respective channel
adjustment of sound characteristics
(HI = high frequency range, MID = middle frequency range, LOW = low
frequency range)
indication of the corresponding input level