Troubleshooting - easymaxx SP-11 Mode D'emploi

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the following steps, contact the cus-
tomer service department.
Do not attempt to repair an electrical device yourself!
Problem Possible cause
No function. In mains power mode: The connect-
ing cable is not connected correctly.
In mains power mode: The plug
socket is defective.
In mains power mode: No mains volt-
age is present.
In battery mode: The batteries are
too weak or inserted incorrectly.
No sound can The volume is set to a minimum
be heard. level.
If an external device is connected:
The devices are not connected to
one another correctly.
The external device is not switched
on or its volume is too low.
The battery output of the external
device is too weak.
Poor sound Interference from electronic devices
quality / such as televisions, stereo systems,
mobile phones, computers etc.
interference
Radio operation: Steel or reinforced
concrete in multi-storey buildings
may block the radio signal.
Radio operation: Interference may be
caused by a nearby radio mast.
21
Fix
Correct the connection.
Try another plug socket.
Check the fuse of the electri-
cal distributor (fuse box).
Insert new batteries and check
the polarity.
Check the volume setting.
Check the connection of both
devices and correct it if neces-
sary.
Switch on the external device
and check its volume setting.
Insert new batteries.
Keep the device away from
electronic devices.
Place the radio near a window.
It may be helpful to use the
extendable aerial. Try varying
the length and angle of the
aerial.
EN