Playback Via Bluetooth - easymaxx SP-11 Mode D'emploi

Playback via Bluetooth

NOTICE: Read the operating instructions for the Bluetooth
1. Switch on the device by pressing the POWER button (10).
2. Keep pressing the FUNC button (7) until the BT operating lamp (20) lights up. The
radio can now be found by the Bluetooth
3. Switch on Bluetooth
able devices.
4. Select "Design Radio" and connect. As soon as both devices are connected to one
another, the BT operating lamp is lit constantly.
5. The playback can be controlled both via the Bluetooth
PREV (5), NEXT (6), PLAY (9) buttons and the volume control (16) of the radio.
USB
1. Make sure that the device is switched off. Press the POWER button (10) to switch
off the device.
2. Plug the USB connector of a storage medium into the USB socket (4).
3. Switch on the device by pressing the POWER button.
4. Keep pressing the FUNC button (7) until the USB/SD/AUX operating lamp (21) lights
up blue.
5. Control the playback via the PREV (5), NEXT (6), STOP (8), PLAY (9) buttons and
the volume control (16).
6. Switch off the device before the USB connector is pulled out.
SD Card
1. Make sure that the device is switched off. Press the POWER button (10) to switch
off the device.
2. Insert an SD card into the SD CARD slot (3).
3. Switch on the device by pressing the POWER button.
4. Keep pressing the FUNC button (7) until the USB/SD/AUX operating lamp (21) lights
up red.
5. Control the playback via the PREV (5), NEXT (6), STOP (8), PLAY (9) buttons and
the volume control (16).
6. Switch off the device before the SD card is pulled out.
19
®
on the Bluetooth -enabled device and start searching for avail-
® ®
-enabled device.
®
-enabled device.
®
® -enabled device and via the
EN