Fossil JS25 Instructions page 4

PIN LINK DIAGRAM
PIN
PUSHER
ARROWS
Link Removal
To remove a link from a pin link bracelet, you
will need the bracelet holder, pin pusher, and
chain nose pliers (see pin link diagram).
1. Open the clasp on the bracelet.
2. Look on the inside of the bracelet and locate
the arrows near the clasp (see diagram).
3. Place the band into the appropriate size
slot of the bracelet holder with the arrows
pointing down (see diagram).
4. Center the desired pin to be removed
over one of the holes in the bottom of the
bracelet holder.
5. With the pin pusher, push the pin, as far as
possible, through the link.
6
CHAIN NOSE
PLIERS
BRACELET
HOLDER
6. Remove the watch from the bracelet holder
and simply finish pulling out the pin with the
chain nose pliers.
NOTE: Two pins hold each link in place
and must be taken out before a link can be
removed. Please note that the pins are partially
split down the center.
WATER RESISTANCE
See caseback for water resistance rating.
The water resistance rating provides guidelines
for appropriate water-related exposure to avoid
damage to internal watch components. Please
see chart for recommended usage guidelines.
In order to ensure water does not enter the
watch and cause damage to it, please follow
the instructions listed below:
• Do not adjust the crown while the timepiece
is in contact with water.
• Ensure the crown is in the closed position
before contact with water. For timepieces
with screw-down crowns, ensure the crown
is completely tightened before contact with
water.
• For timepieces with pusher-enabled
functionality, do not engage the function
underwater.
• Exposure to extreme atmopheres is not
7