Usage Instructions; Maintenance And Storage - Hudora BigWheel 205 Instructions De Montage Et Mode D'emploi

USAGE INSTRUCTIONS

NOTHING'S EASY AT FIRST ...
... most accidents happen to "beginners" within the first ten minutes.
Particular care should be taken during this stage.
DRIVING INSTRUCTIONS
The scooter moves when a foot is used to regularly push off, just as with
well-known children's scooters. Braking is no problem either - simply
step on the friction brake over the back wheel (mudguard).
We recommend folding the scooter by hand after each use or using the
stand. The side stand is in the direction of movement located on the left
hand side under the deck. Its use is ensured through simply folding and
unfolding. Aluminium is a good and light material but should also be
handled carefully as it is not as hard as steel, for example.

MAINTENANCE AND STORAGE

Use a dry or damp cloth only to clean the product; do not use special
cleaning agents! Check the product for damage or traces of wear and tear
before and after each use. Do not make any structural changes. For your
own safety, please use original spare parts only. These can be sourced
from HUDORA. If parts become damaged or if sharp edges or corners
should develop, the product may not be used any more. If in any doubt,
please contact our service team (http://www.hudora.de/service/). Store
the product in a safe place where it is protected from the elements, can-
not be damaged, and cannot injure anyone.
Replace damaged or worn assembly parts in order to ensure the safety
of your scooter.
WHEEL CHANGE
Replacement wheels are available as accessories from http://www.
hudora.de/overview/bigwheel/ and should be replaced when they are
worn down. To change the wheels, loosen the axle fitting with two Allen
keys and take the wheels off the axle. A screwdriver or Allen key can be
used to push the bearings out of the wheel to use them in the new wheel.
However, it is usually advisable to change the bearings when the wheels
are changed. Put the bearings into the new wheel with the bolt spacer and
mount them to the frame with the axle screws. Make sure the axle has
been screwed on tightly before starting again!
BEARINGS
Your kick scooter is equipped with precision ball bearings, which were fil-
led with grease under high pressure, during manufacture. For this reason,
the rollers of the kick scooter only run lightly and swiftly, while under load.
Bearings are maintenance-free, but they are wear parts. Caution! Worn
bearings make conspicuous audible noises and their function is cons-
trained. In order to maintain optimal riding pleasure and to ensure lasting
safety, you should replace bearings, as soon as they begin to exhibit signs
of being worn. In the case of full load and daily use we recommend the re-
placement of the rollers and bearings twice a year. Bearings are available
as accessories under http://www.hudora.de/overview/bigwheel/.
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate col-
lection point provided in your area. Local waste management companies
will be able to answer your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise ho-
wever, we put just as much effort into rectifying them. Therefore, you can
find numerous information on the product, replacement parts, solutions to
problems and lost assembly manuals at http://www.hudora.de/service/.
SPARE PARTS AND ORIGINAL
ACCESSORIES AVAILABLE AT:
http://www.hudora.de/overview/bigwheel/
All images are examples of the design.
7/16