Charging The Battery; Swivelling The Device; Tripod Thread; Operation - Parkside Performance Ppbsta 20-Li A1 Traduction Des Instructions D'origine

GB MT
status of the battery by illuminating
the corresponding LED lights.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (20) from the
device.
2. Push the battery (20) into the char-
ging slot of the battery charger
(21).
3. Connect the battery charger (21) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (21) from the mains.
5. Pull the battery (20) out of the bat-
tery charger (21).
Control LEDs on the charger (21):
green red
lights up —
— lights up Battery is char-
— flashes
flashes flashes

Swivelling the device

Notes (Fig. A)
• The device has a usable angle of
0–165°.
22
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
Battery is over-
heated
Battery is defect-
ive
Do not swivel the device outside
this range.
• The maximum angle is only pos-
sible on a tripod.
• The base (5) is infinitely adjustable.
• The base (5) cannot be fixed.

Tripod thread

You can use the ⅝" internal thread (6)
to screw the device onto a tripod (not
included).

Operation

Working instructions

WARNING! Do not look into the
light source.
The device can either be connected
to the mains power supply or oper-
ated with X 20 V Team batteries.
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.
NOTICE! Risk of damage! An incor-
rect battery can damage the device
and battery.
Inserting the 20 V battery
1. Push the battery (20) along the
guide into the battery holder (7).
You will hear the battery click into
place.
Removing the 20 V battery
1. Press and hold the battery release
(19) on the battery (20).
2. Pull the battery out of the battery
holder (7).

Switching on and off

Switching on
1. Press the On/Off button (11).
The light (2) shines at level 1.