Richell 94951 Manuel D'instructions page 6

Set the Gate with the Door opening to the right as seen from
the side where cats are contained.
Place shafts located on the Top and the Bottom of Frame on the
right as seen from the side where cats are contained.
※ If the Gate is installed with the Door opening to the left, a cat
might unlock the door to escape.
1
Stand the Outer Frame
Stand the Outer Frame at installa-
tion location with the Rubber feet
on the bottom.
2
Pull out the Adjuster Knob
Pull the Top Adjuster Knob out from the Outer Frame until the
Rubber on Adjuster reaches the wall.
Rubber on Adjuster
Pull
3
Secure the Outer Frame
① Turn the Adjuster Knob in the direction of arrow
to bring it closer to the Outer Frame.
Adjuster Knob
※ Please tighten the 2 Adjuster Knobs until
no space is between them and they do
not come loose.
Rubber Feet
Caution
Rubber on Adjuster must be
placed in a horizontal
direction.
Side View
② Continue to turn the Adjuster Knob to increase the tension until
the Rubber on Adjuster is securely adhered to the wall.
Follow the same procedure to secure the Bottom Adjuster.
Turn
Outer Frame
6
Top View
Right-Opening
Caution
●
Install this product at right angles
with the wall and floor.
Right Angle
Adjuster Knob
Rubber on Adjuster
Tension Force
Warning
● Make sure the Rubber on Adjusters are adhered to the
wall at 4 locations. If it is not adhered, the Gate may fall
and result in an unexpected accident.
Shaft
Right Angle
3.9" or less
Top View
Right Angle
Side View
Turn