Uline H-4068 Instructions D'assemblage

H-4068, H-4069, H-4072
π
H-5012, H-5013, H-5014
H-5015, H-5016, H-5017
GRAVITY ROLLER
CONVEYORS
TOOL NEEDED
9/16" (14 mm) Wrench
BOLTING CONVEYOR FRAME(S) TO H-STAND LEG
SUPPORTS
NOTE: H-Stands are sold separately. Hardware
included: four hex head bolts and four flange
nuts.
1. Hardware is pre-screwed into the tops of the
H-Stands. Remove the hardware. (See Figure 1)
Figure 1
2. Bolting two H-Stands to one conveyor frame:
Position H-Stands on the ends of the conveyor frame.
Fasten bolts through conveyor and H-Stand.
(See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
ASSEMBLY
3. Bolting a single H-Stand to two conveyor frames:
Position the H-Stand halfway between the ends of
two conveyor frames, lining up one hole on each
conveyor with the H-Stand. Fasten bolts through
conveyors and H-Stand. (See Figure 3)
CONNECTING MULTIPLE CONVEYOR
FRAMES TOGETHER
1. Lift the hook over the bolt to keep it in place.
(See Figure 4)
Pour le français, consulter la page 3.
NOTE: Each conveyor frame includes mounting
holes for an optional center leg support.
Adding a third support increases weight
capacity.
Figure 3
Figure 4
Para Español, vea página 2.
0824 IH-4068