Harvia Sentio Concept R mini combi CP-RMC-35 Instructions D'installation Et Mode D'emploi page 61

Instructions for use for the user
Filling the evaporator
CAUTION!
Risk of scalding
If you pour water into the hot evaporator tank, hot steam is created.
● NEVER pour water into the hot evaporator tank.
● Check and fill the evaporator tank each time before starting combi mode.
● If the overheating protection has switched off evaporator heating, or
if your sauna control unit reports a lack of water, allow the evapora-
tor to cool down BEFORE you pour water into the evaporator tank.
CAUTION!
Risk of scalding
If the evaporator tank is too full, boiling water will spray out of the evapo-
rator tank.
● Only fill the evaporator tank up to the maximum mark.
1. Remove the ceramic bowl 1 and the steam
funnel 2.
2. Place a receptacle (at least 5 litres) under
the ball valve at the bottom of the evaporator.
3. Turn the ball valve to the left, until the remain-
ing water flows out.
4. When the evaporator tank 3 is empty, close
the ball valve.
5. Fill the evaporator tank 3 with fresh tap
water up to the maximum mark. You will need
about 5 litres of water for this. This amount of water allows the evaporator
to be operated for approximately 1 hour.
6. Replace the ceramic bowl 1 and the steam funnel 2.
p. 27/34
1
2 EN
3