Fm Radio Function; Bluetooth Operation - Party Light & Sound PARTY-12LED Mode D'emploi

USING THE WIRELESS MICROPHONE
Open the battery compartment and insert two AA batteries with the correct polarity.
Turn the switch on the mic to ON. If the power indicator lamp doesn't flash or doesn't light up, check if the
battery has been properly inserted.
Extend the antenna on the rear panel of the unit to its full length in a vertical position.
Start singing into the microphone and adjust the volume to the desired level.
The antenna must not touch any metal object.
When the indicator lamp on the mic lights up, you have to replace the battery.
Don't use the microphone close to the speaker in order to avoid feedback.
KARAOKE Function
This feature is available with any input. Play a track through AUX/USB/SD/FM/Bluetooth, connect a
microphone and sing along.
Built-in REC function
1. Plug a microphone into the MIC IN input.
2. Insert a USB/SD card into the corresponding port. Press Input selector button and select USB/SD mode.
3. If the USB/SD card is plugged into the speaker for the first time, the system will automatically create a
folder named 'record' to save the recorded files.
4. When you are ready to record, press REC button to record the sound of the wireless or wired
microphone.
USB/SD Operation
Keep the speaker away from high temperatures, strong magnetic fields and any equipment that could
generate interference. If the speaker stops working, switch it off and on again, or unplug USB/SD/MMC
card and re-plug it. The speaker should be back to normal status.
The maximum size of USB/SD device that can be connected is 32 GB.
Supported music formats: MP3, WMA

FM RADIO FUNCTION

1. Turn on the unit and press repeatedly the input selector key on unit and select FM function (the display
will show the frequency).
2. Press the PLAY/PAUSE button on the unit or the key  on remote control to activate the auto
memory (the radio starts an automatic search for available radio stations and saves them automatically).
The station's number stored depends on the radio signal in your area.
During the search, press PLAY button on the remote control to stop searching.
3. Use the  and  keys to listen to the various radio stations saved in memory.
4. To change to a preset station, use the number keys on the remote control.
For example, to call up the station number 12, first press 1 and then 2.

BLUETOOTH OPERATION

1. Turn on the unit and press the input selector button on unit to select the Bluetooth function.
2. Activate the Bluetooth feature on the external device to be paired.
3. Initiate a search for devices. The device shows up as "PARTY-LED".
4. Press the   to start playing and the buttons  and  for the selection of songs.
©Copyright LOTRONIC 2018
PARTY-12LED / PARTY-15LED
5