Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
3. Safety Instructions
The Isolator terminal IP 30 may be operated only if they are clean
and not damaged in any way and may be used only within the
specified temperature class and the temperature range indicated for
them (see type label).
The Isolator terminal IP 30 may be assembled and disassembled
only by qualified personnel who are authorised and trained to install
electric components in hazardous areas.
Utilisation in areas other than those specified or the modification of
the product will exempt BARTEC from liability for defects and any
further liability. It is not permissible to alter or modify the module.
The generally applicable statutory rules and other binding directives
relating to workplace safety, accident prevention and environmental
protection must be observed.
Danger, Warning and Note Symbols
Safety instructions and warnings are specially highlighted in these
operating instructions and marked by symbols.
DANGER
The DANGER sign draws attention to a direct
threat which if not avoided will lead to death or
very serious injuries.
WARNING
WARNING draws attention to a possible threat
which if not avoided can lead to death or very
serious injuries.
CAUTION
CAUTION draws attention to a possible danger
which if not avoided can lead to slight or minor
injuries.
ATTENTION
ATTENTION draws attention to a potentially
damaging situation which if not avoided can
cause damage to the equipment or to objects
in its vicinity.
Important instructions and information on effective,
economical & environmentally compatible handling.
BARTEC GmbH
Max-Eyth-Straße 16
EN
97980 Bad Mergentheim
Germany
Control units MODEX
(Translation)
Isolator terminal IP30, type 07-7331-6131/EE00
Phone: +49 7931 597-0
Fax: +49 7931 597-119
4. Technical Data
Physical features
Construction
Enclosure material
Protection class
(EN/IEC 60529)
Terminals
Switching insert
Terminals with cover
Electric connections
Attachment onto mounting rail
(EN/IEC 60715)
Terminal marking
Terminal screws
Terminal screw torque
Dimensions in mm
(width x height x depth)
Mounting position
Weight
User environment
Ambient temperature
Storage/transport
temperature
Relative air humidity
info@bartec.de
Reservation Technical data subject to change without notice.
www.bartec-group.com
Flameproof clip-on enclosure
High-quality thermoplastic and
duroplastic
IP20 (minimum)
IP54
IP30
terminals 2.5 mm
stranded
TH 35 x 15 (7.5)
inscription label
M 2.5 x 0.45 mm
0.4 Nm
64 x 71 x 15 mm
any
approx. 245 g
-40 °C to +70 ° C
-20 °C to +70 °C
5 to 95 % non-condensing
Changes, errors and misprints may not be used
as a basis for any claim for damages.
, fine-
2
2/6
Publicité
