Publicité
Les langues disponibles
Les langues disponibles
3.2- Additional safety rules for electric power tool
Electric tool
• When the tool is not in use or before performing cleaning, turn it off and remove the battery
pack.
• Do not leave the tool unattended while in use.
• Keep handles and grasping surfaces dry, clean and free from oil and grease.
• Do not expose the tool to rain or wet conditions. Water entering the tool will increase the risk
of electric shock.
• Do not operate the tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
• Maintain labels and rating plate through the life of service.
• Do not use the tool if the switch does not turn on and off. Any tool that cannot be controlled
with the switch is dangerous and must be repaired.
• This tool is not intended for use by children and persons with physical, sensory or mental
limitations or a lack of experience or knowledge.
• Store idle power tool out of the reach of children and do not allow persons unfamiliar with the
tool or these instructions to operate the tool.
Battery charger (not included)
• Do not abuse the power cord. Never use the cord for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp edges or moving parts.
• Use the power adaptor indoor only.
• Do not place any object on top of charger or on a surface that might block the ventilation slots
and result in excessive internal heat. Place the charger in position away from any heat source.
• Do not disassemble charger. Take it to authorized service centre when service or repair is
required. Incorrect reassemble may result in a risk of electric shock or fire.
• Perform charging in ambient environment.
• Unplug the charger from the main when not in use.
Battery pack (not included)
• Do not incinerate the battery even if it is severely damaged or is completely worn out. The
battery can explode in fire.
• Leakage of liquid from the battery cells may occur under extreme usage or temperature
conditions.
• Do not connect the positive and negative terminals with metal objects. Battery could be short-
circuited and resulted in battery damage or fire.
• Recharge only with the charger specified by the manufacturer.
3.3- Special warnings when using this product
• IMPORTANT! The USB output port (11) is only intended for charging lower voltage device.
IV. GETTING STARTED
WARNING!
Before any intervention on product, ensure that power is set to the "OFF" position,
then remove the battery pack and disconnect the product from the electricity mains.
4.1- Unpacking
• Remove the product from packaging.
• Check if the product and accessories (if any) are intact.
Page 12 / 27
Publicité
