How To Reverse The Door; How To Replace The Hinges, Door And Drawer - KENMORE ELITE 596.72282200 Guide D'utilisation Et D'entretien

Installing your refrigerator,

How to reverse the door

1. Perform all steps listed in How to
Replace the Hinges, Door and
Drawer (page 8).
2. Transfer cabinet
plugs and screws to
opposite side of
cabinet.
Remove plugs with flat blade of
screwdriver wrapped in masking
tape.
Remove center mullion screws
with " hex head driver.
5 ⁄
16
CAUTION
To avoid possible injury and damage
to property:
DO NOT remove sub cap when
removing door trim.
Place doors on
surface protected by towels or rugs
while working directly on door.
3. Remove door stop
from fresh food
door with Phillips
screwdriver.
4. Remove bottom door trim by
removing 4 Phillips screws. Lift
handle corner of trim and slide
toward hinge edge of door.
5. Remove top door trim by removing 4
screws*. Lift handle corner of trim
and slide toward hinge edge of door.
Retain all screws for later use.
6. Reverse handle by removing two
screws* from top and bottom edge of
handle and reattaching handle on
opposite side of door.
* Fasteners may require either a T-15 Torx
8
Torx ® is a registered trademark of Textron Inc.
7. Install top door trim on bottom side
of door, and bottom trim on top side
of door.
Locate hinge hole corner of trim.
Install hinge hole corner of trim on
hinge side first, then install handle
edge of trim.
8. Proceed to How to Replace the
Hinges, Door and Drawer.
How to replace the
hinges, door and
drawer
1. Install stabilizing brackets with
head driver.
2. Replace toe grille and bottom bracket
covers.
Snap bottom portion into place
nonabrasive
first. Press down on top part of
grille until top portion snaps into
place.
3. Pull both rails out to full extension.
4. Hook door supports into rail tabs, as
illustrated, and lower door into final
position.
® driver or a Phillips screwdriver.
cont.
3 " hex
⁄
8
5. With drawer pulled out to full
extension, insert lower basket by
aligning tabs on both side of lower
basket with notches in rail assembly.
6. Slide upper basket into refrigerator.
Make sure that rear of basket hooks
behind rail catch.
7. Install center hinge with Phillips
screws.
8. Install center hinge pin with
head driver.
Replace any applicable door
shims.
Make sure the hinge pin is
installed tightly.
9. Install top hinge loosely with
head screws.
10. Place hinge side of refrigerator door
on center hinge pin.
11. While holding refrigerator door
upright, tighten door top hinge with
" hex head driver.
5 ⁄
16
12. Replace top hinge cover on hinge.
5 " hex
⁄
16
" hex
5
⁄
16