Abus TVVR20001 Manuel Utilisateur page 113

Handle:
Parameter
Pop-up Image on Moni-
tor
Audio Warning
Notify Surveillance Cen-
tre
Send Email
Trigger Alarm Output
Schedule:
Here you can define in which period of time the reaction
to the alarm input shall be handled.
Setting
A message appears on the
monitor.
The device emits a repeat-
ing tone.
Sends an alarm signal to a
PC with ABUS CMS soft-
ware. The software must be
enabled and the recorder
set to surveillance mode on
the PC.
An e-mail is sent to a spe-
cific e-mail address (see
page 48).
See page 51.
Triggered Camera:
Parameter Setting
Record Using this parameter, you can select
which cameras should be used for re-
cording after the alarm input is trig-
gered.
Enable Sched- Using this parameter, you can select
ule on which cameras the schedule
should be activated. For example, if
you have installed the ABUS IP alarm
module, then you can use the
Secvest Key to activate guard mode
in the recorder when exiting the prem-
ises. The recording mode (duration,
motion detection, alarm) stored in the
schedule is then used. In this way,
you can activate the recorder inde-
pendently from the schedule and pre-
vent false alarms.
Ensure that the schedule is not acti-
vated initially so that it is not disarmed
during activation.
Alarm
51