Time; Sample Settings - GF JRG CleanLine Filter Notice D'utilisation Et D'entretien

E

5.4. TIME

„TIME" defines the flushing time per filter
chamber.
"TIME" allows you to change the factory setting
(1 s). If you press the "TIME" key, the LEDs will
flash one at a time. After selecting the desired
value, the setting is saved after 3 seconds.
The following settings are available:
1 s = 1 second (factory setting)
3 s = 3 seconds
6 s = 6 seconds
60

5.5. Sample settings

The system is backwashed every 30 days,
at 8:00 pm, each chamber for 3 seconds.
Settings:
INTERVAL = 30 d
START = (the system is commissioned at
8:00) => 12 h
TIME = 3 s
Press "INTERVAL" and "TIME" simultaneously
for 2 seconds to release the key lock. Now you
can adjust the parameters. The settings are
saved after 3 seconds. If no key is pressed within
10 seconds, the key lock is reactivated and the
selected parameters are saved. This is followed
by an automatic backwash run. After backwash-
ing, the LEDs go out.