Transport And Storage; Safety Measures - BEHA UNITEST Telaris 0100 Mode D'emploi

2.0 Transport and Storage

Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, we recom-
mend that accumulators are removed when not
using the instrument over a certain period of time.
However, should the instrument be contaminated
by leaking battery cells, you are kindly requested to
return it to the factory for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of at least 2
hours is required prior to instrument operation.

3.0 Safety Measures

The UNITEST Telaris 0100 has been designed and
checked in accordance with the safety regulations
for Electronic test and Measurement Instruments
EN 61010 and IEC 61010, and left our factory in a
safe and perfect condition.
The respective accident prevention regulations
established by the professional association for
electrical systems and equipment must be
strictly met at all times.
In order to avoid electrical shock, the valid safe-
ty and VDE regulations regarding excessive
contact voltages must receive the utmost at-
tention when working with voltages exceeding
120V (60V) DC or 50V (25V)rms AC. The val-
ues in brackets are valid for limited ranges (as
for example medicine and agriculture).
Transport and Storage / Safety Measures
If the operator's safety is no longer guaranteed,
the instrument is to be put out of service and
protected against use. The safety can no longer
be guaranteed if the instrument (or leads):
• shows obvious damage
• does not carry out the desired measurements
• has been stored for too long under un-
favourableconditions
• has been subjected to mechanical stress dur-
ingtransport.
The instrument may only be used within the op-
erating ranges as specified in the technical data
section.
Avoid any heating up of the instrument by di-
rect sunlight to ensure perfect functioning
and long instrument life.
The opening of the instrument for fuse re-
placement, for example, may only be carried
out by professionals. Prior to opening, the in-
strument has to be switched off and discon-
nected from any voltages.
When handling isopropanol or isopropyl alco-
hol, the instructions of handling stated in the
safety data sheet complying with the decree on
dangerous materials have to be respected. Dur-
ing usage, explosive/easily inflammable
vapour-air mixtures may be generated - danger
of explosion !
29