Behringer ULTRA TREMOLO UT300 Mode D'emploi

ULTRA TREMOLO UT300
Classic Tremolo Effects Pedal
Thank you for showing your confidence in us by purchasing the
Behringer ULTRA TREMOLO UT300. This high-quality effects pedal
is designed to provide guitarists easy-to-use tremolo effect styles.
Thanks to its high-performance features you get the classic, warm and
mind-bending tremolo effects of vintage '60s amps.
The tremolo effect is achieved by periodic modulation of the input signal
level. This results in a continuous change from low to high level that has
a quivering, tremulous sound character.
1. Controls
The RATE control adjusts the speed of the tremolo effect.
(1)
The DEPTH control adjusts the intensity of the effect.
(2)
The WAVE control alters the LFO waveform that modulates the
(3)
input signal from triangle to square. This way you can achieve
practically any tremolo sound, from classic to radical styles.
The ON/BATT LED illuminates when the effect is activated. It also
(4)
serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(5)
Use this ¼" TS IN connector to plug in the instrument cable.
(6)
The ¼" TS OUT connector sends the signal to your amp.
(7)
Use the DC IN connection at the front of the unit to plug in a 9 V power
supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
V 1.0
(4)
(1)
(7)
(2)
(3)
(6)
(5)