Honeywell DH45W Mode D'emploi page 9

USE & OPERATION (CONTINUED)
CONTROL PANEL (CONTINUED)
Timer Control
The dehumidifier can be set to automatically switch ON or OFF after a selected period of time
(between 1-24 hour intervals). The Timer hours selection is displayed on the Timer/Temperature
Display Screen.
NOTE: Before setting the Timer control, make sure there is power to the unit.
Auto-Off Timer:
While the unit is running, first press
hours you want the unit to run before it switches off. The unit automatically switches off after the set
time period has elapsed. You must repeat the Timer set up procedures to reset the Timer for next use,
if needed.
Auto-On Timer:
When unit is in standby mode,
want the unit to automatically start running. The previous fan speed and humidity setting will be
maintained. The unit will continue running until the water tank is full (unless the unit is set up for
continuous draining) or until you switch it off manually.
NOTE: To cancel any Timer settings, simply press
Timer display shows '0'.
and then tap or hold the ▲ or ▼ to select the number of
press and ▲ or ▼ to select the number of hours until you
and then tap or hold the ▲ or ▼ until the
EN 8