Honeywell DH45W Mode D'emploi page 13

USE & OPERATION (CONTINUED)
DRAINING THE WATER (CONTINUED)
THIS IS ONLY FOR MODELS WITH BUILT-IN DRAIN PUMP
DH45PWKN /DH45PWGN / DH50PW / DH70PW / DH70PWKN / DH70PWGN
3. Continuous Water Drainage – Using the Drain Pump Option (Drain Tube included)
The Continuous Drain Pump is available if you want to use the continuous drain function, but the
drain is further away, or located above the dehumidifier. A 16.4ft (5m) long drain tube*
can be attached to the continuous drain pump located on the back side of the dehumidifier.
When the water level in the water tank reaches a certain level, the drain pump will automatically
pump the water out of the tank to the drain. This allows you to drain water condensation vertically or
horizontally, even if the drain is located above the dehumidifier.
3.1 Unwrap the drain tube from the dehumidifier and locate the drain tube connector on one end
of the drain tube.
3.2 Insert the drain tube connector into the drain pump hole located on the rear side of the
dehumidifier.
3.3 Push the drain tube connector into the drain pump hole until you hear a "click" sound.
3.4 Place the other end of the drain tube into the sink or drain. The water can be pumped up to
16.4ft (5m) vertically or horizontally.
NOTE: DO NOT use an alternative drain tube that is longer than the one provided with the
unit.
3.5 To disconnect the drain tube, press the release button above the drain pump hole while
pulling the drain tube connector away from the drain pump hole.
3.1
Drain
Tube
3.3
*Continuous Drain Tube is included in Dehumidifier models with Continuous Drain Pump feature only.
3.2
Drain Tube
Connector
3.5
Release
Button
EN 12
Drain Pump
Hole