Cleaning The Mixer - Hamilton Beach Commercial Mix'n Chill Manuel D'utilisation

Cleaning the Mixer

Cleaning and Sanitizing the Container, Spindle, and Agitator
wWARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts before operating.
Failure to do so can result in death
or electrical shock.
Cleaning
1. Place a drop of detergent and 1 cup (250 ml) of
water into the mixing container.
2. Position the container under the mixing spindle
and mix on low speed for 5 seconds. Empty
the mixing container.
3. Place 1 cup (250 ml) of clean water into the
container and repeat mix for 5 seconds to rinse.
NOTE: Inspect agitators daily. Replace agitators
every 90 days.
Sanitizing
For best results, use the Hamilton Beach Universal
Container (#110E).
1. Fill the container with sanitizing solution (1 table-
spoon [15 ml] of household bleach per 1 gallon
[3.8 L] of water at 50°–70°F [10°–21°C]) to 3/4 full.
Position the container under the mixing spindle
and run on low speed for 1 minute.
2. Remove container. Empty sanitizing solution and
rinse container.
3. To dry, run the mixer on low speed for 30 seconds
with empty container in place. DO NOT RINSE
after sanitizing is completed.
NOTE: If preferred, the container and agitator may
be cleaned in a commercial dishwasher.
7