Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to Operate the Machine
Operating Instructions
1.
Install the abrasive disc.
2.
Connect the dust management system.
3.
Connect the extension cord to a wall outlet and then to the
machine.
4.
Raise the sanding disc from the surface then activate the
master control switch.
5.
Lower the sanding disc to the surface and begin sanding.
Do not press down on the handle while sanding. Doing so
will promote objectionable scratches and an uneven finish.
Depending on technique and desired results, use one or a
combination of the two methods shown in figures 7.1 and 7.2.
6.
For optimum dust management performance when using the
included dust bag (53544C), empty frequently. Do not overfill.
Empty when dust reaches full line.
WARNING!
Follow all instructions found in this manual and on the dust bag
pertaining to the safe storage and handling of sanding dust.
Clarke
®
American Sanders
Operator's Manual (EN) - CE7 Pro, SE7 Pro, CE7 Pro+, SE7 Pro+
ENGLISH
EN
Figure 7.1
Figure 7.2
- 11 -
Publicité
Chapitres
Table des Matières
