S&P AIRSENS RF CO2 Mode D'emploi page 16

MAINTENANCE
Disconnect from supply before removing. Prevent the possibility of anyone else
EN
connecting it while it is being inspected. Regular inspection of the appliance is
required, the frequency must be depend of the working conditions to avoid the
accumulation of dirt that could trigger risks and would reduce the life expectan-
cy. In all maintenance work, safety regulations in each country must be taken
into account.
PUTTING OUT OF SERVICE AND RECYCLING
Fig. 1: Electronic board
100-240V
50/60Hz
power supply
0-10Vdc
output
Modbus
Ending
Modbus
network
Relay
16
EEC legislation and our consideration of future generations mean
that we should always recycle materials where possible; please do
not forget to deposit all packaging in the appropriate recycling bins. If
your device is also labeled with this symbol, please take it to the near-
est Waste Management Plant at the end of its servicable life.
L
N
Out
0V
D0
D1
0V
NO
C.
NC
3-LED
intensity
Button
50 50
25 75 25
J9
0 100 0
%
P2 P1
ON
1 2 3 4 5 6
SW
Operation
modes
D18 D16 D17
75
100
%
Set
point