Publicité
Les langues disponibles
Les langues disponibles
- en -
Dear customer
Thank you very much for choosing a weka product.
•
Read these instructions through completely before assembling your product in order to avoid
errors in assembly or damage.
•
IMPORTANT
Please use the enclosed packing list to check immediately that your weka product has
been delivered complete and intact.
•
Please do not dispose of the packing list before the guarantee period has expired. This list
enables you to check that all the individual parts are present. It should be retained along with the
proof of purchase. Any complaints which may arise can probably be easily rectified with this list.
The item numbers on the packing list do not correspond to the item numbers in the following
assembly instructions.
•
We recommend that 2 people carry out the assembly.
•
In order to prevent accidents, we recommend that children are kept out of the direct vicinity during
assembly.
•
We reserve the right to make further technological developments. This means that there many be
minor deviations in the illustrations.
•
Please do not simply throw away the packaging material. Paper, card and corrugated board as
well as plastic packaging materials should be placed in the correct collection containers.
RECOMMENDATIONS
•
Please drill pilot holes for all screw connections to avoid damaging the wood. The following
symbol in the instructions will indicate when this is necessary:
•
Protect the wood from hours of direct sunlight and moisture.
•
Wood is a natural product. Fluctuations in colour, knots and cracks are normal and have no
influence on the statics.
•
A prerequisite for successful assembly, is the anchoring of the studs in the concrete foundation
using H stud supports. The stud supports are available as weka accessories for an additional cost.
•
A foundation plan can be obtained from your specialist dealer!
•
In order to facilitate the precise alignment of the H anchors, mark the necessary post clearances
on a piece of guide wood and fix the anchors in place with screw clamps (figure 1)
•
Then suspend the H anchors in the base holes already prepared. A minimum clearance of 2 cm is
to be maintained between the upper edge of the foundation and the upper strut.
•
The required gradient can also be achieved by shortening the studs.
•
After the holes have been filled with B25 concrete, the foundation must be allowed to set for at
least 3 days.
GUARANTEE CONDITIONS
weka Holzbau GmbH provides you with a 5-year guarantee for design and processing quality. Within
the guarantee time, faulty parts will be replaced free of charge. Costs arising as a result of the
exchange are not included in the guarantee claim.
Guarantee claims may only be made in conjunction with the original packing list and proof of
purchase.
Techn. Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
+
Copyright weka-Holzbau GmbH, Neubrandenburg
3
Publicité
