Installation Instructions; Safety Instructions; Setting Up; Accessories - Calira EVS 36/20-DS/IU Mode D'emploi

Installation instructions

Safety instructions

This device contains components that may generate
sparks or electric arcing!
Connecting the device to the power supply must comply with
the applicable national installation regulations!
This device contains components that may generate electric
arcing and sparks. Therefore when operating the device in a
garage or a similar location, it must be contained in a room or
housing designed for this purpose!
If the device is used in campers, caravans and boats, the
device and the battery must be installed apart in separate and
well-ventilated boxes!
The installation and connection of electrical apparatus must
always be performed by appropriately trained personnel!
Always make sure that the power supply is disconnected! Pull
out the mains plug!
When connecting the device, use only the supplied parts and
the specified cable cross-sections and fuses!
Only use suitable and undamaged tools!
Only connect the device according to the supplied connection
diagram!

Setting up

There are various accessory kits available that need to be
ordered separately.

Accessories

(not included)
Quick connector for battery "Quick power"
(part no. H10 432 0110 00)
Temperature sensor for battery II
(part no. H10 012 0003 00)
The device should be set up in a location not exposed to hu-
midity and damp. The setting up location must be clean, dry
and well-ventilated. During operation, the housing may heat
up to approx. 75 °C. Therefore maintain a minimum clear dis-
tance of 100 mm and make sure that the ventilation slots are
not covered.
The installation space for the charger must be no less than
the dimensions given as follows, to ensure that a minimum
all-round distance of 100 mm is maintained.
Length: 502 mm / Width: 373 mm / Height: 245 mm
The device should be placed as close as possible to the bat-
tery, but always in a separate box. The box for the battery
must have a ventilation hole facing towards the outside.
The separate box for the device must be provided with ventila-
tion holes at the top and sides, with a total area of 100 cm².
29