Important Advice - Innotek FieldPro FP-RANGER -E Manuel De L'utilisateur

TROUBLESHOOTING
If the Transmitter and Receiver appear to
be not working, try the following:
• Adjust the collar strap to fit better.
• Test the Receiver using the Test Light
(Instructions are on page EN-16). If no
light, recharge the Receiver's battery.
• If the Transmitter display is off, first try
pressing any button. If the display
remains off, recharge the Ranger
Transmitter or replace Scout
Transmitter batteries.
• Carefully turn on the components as
shown in the Quick Start Guide
(beginning of this manual).
• Check that the Receiver contacts are
properly tightened.
• Ensure that the Receiver contacts are
touching the dog's skin.
• If necessary, trim the dog's hair or use
the longer contacts to ensure proper
skin contact. Never shave the dog's
neck.
• Try a stronger stimulation level.
If you still have a problem which you
believe requires service, please contact
an authorized INNOTEK Service Center
to speak with an INNOTEK agent. Many
problems can be remedied over the
telephone without returning the unit for
service.
FieldPro-E Owner's Manual

IMPORTANT ADVICE

1. Read the entire Owner's Manual and
follow all directions. If you have any
questions,
authorized INNOTEK Service Center.
2. This system is intended for use only
on dogs. Never attempt to use it for
any purpose not described in this
manual.
3. Keep out of the reach of children
4. Never perform set-up procedures
while the Receiver collar is on your
dog.
5. Any collar worn for extended
periods can cause a condition
similar to bedsores, known as
Pressure Necrosis. To reduce the
possibility, you must do the following:
• Never leave the collar on the dog for
more than 12 hours per day.
• Examine the dog's neck daily for any
signs of a rash or a sore.
• Supervise your dog during the first 2
days of training.
• Check the fit to prevent excessive
pressure; you should be able to
insert one finger between the collar
strap and your dog's skin.
• Wash the dog's neck area and the
contacts of the collar weekly with a
washcloth and mild hand soap; rinse
thoroughly.
• If the condition persists beyond 24
hours, consult your veterinarian.
6. Metal tags and collars should be
removed when using the receiver
collar as they may interfere with
proper operation.
7. Do not attempt to dismantle or repair
any components of this system; doing
so w w i i l l l l v v o o i i d d t t h h e e w w a a r r r r a a n n t t y y i i n n f f u u l l l l . .
please contact an
EN-19