GE RAG26AA Instructions D'installation

Before you begin - Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner's Manual for future reference.
INTRODUCTION
These instructions cover the installation of the Aluminum Architectural Rear Grille accessory for 26" GE Appliances
Through the Wall AC Wall Sleeves. The grille securely attaches to the rear of the wall sleeve with four pre-set
stainless steel screws and tabs.
TOOLS NEEDED
• 1/4" Nutdriver • Pliers
CAUTION
Improper installation of accessory grille could result in condenser (outdoor) air recirculation. This
will degrade performance of the unit and possibly shorten product life. Manufacturer does not assume responsibility
for improper installation of grille resulting with condenser air recirculation.
IMPORTANT: Check For Proper Orientation
Before attempting to install grille, be sure to check it for proper orientation. The grille should be oriented with louvers
pitching downward.
STEP 1
center of the outdoor panel to use as a handhold.)
GE is a trademark of the General Electric Company. Manufactured under trademark license.
Installation Instructions
for your new
RAG26AA
Aluminum Architectural Rear
Grille
INSTALLATION
31-5000794 Rev. 0 02-24