Publicité
Les langues disponibles
Les langues disponibles
8.2 Placing Your Refrigerator Under
the Countertop and Adjusting
the Feet
When your refrigerator is placed, the dis-
tance between the wall and the product
should be at least 30 mm as shown in the
figure. The air intake ducts should not be
blocked to avoid a decrease in the perform-
ance of your refrigerator. (140 cm2)
If the refrigerator is not balanced;
It can be ensured to stand balanced by ro-
tating the front legs of the refrigerator as in
the figure. The corner of the leg is lowered
when rotated in the direction of black ar-
row; and it is raised when rotated in the
counter direction. Getting help from a per-
son to lift the refrigerator slightly during
this operation will make it much easier.
9
Maintenance and Cleaning
WARNING:
Read the "Safety Instructions" sec-
tion first.
WARNING:
Unplug the refrigerator before
cleaning it.
• Do not use sharp or abrasive tools to
clean the product. Do not use materials
such as household cleaning agents,
soap, detergents, gas, gasoline, thinner,
alcohol, wax, etc.
• The dust shall be removed from the vent-
ilation grill on the rear of the product at
least once a year (without opening the
cover). Clean the product with a dry cloth.
• Take care to keep water away from the
lamp's cover and other electrical parts.
8.3 Replacing the Illumination Lamp
Call the Authorized Service when the Bulb/
LED used for lighting in your refrigerator
will be replaced.
Lamp(s) used in this appliance cannot be
used for house lighting. Intended use of
this lamp is to help the user place food into
the refrigerator / freezer safely and com-
fortably.
• Clean the door with a damp cloth. Re-
move all contents to remove the door
and body racks. Remove the door racks
by lifting them upwards. Clean and dry
the shelves, then attach back in place by
sliding from above.
• Do not use chlorinated water or cleaning
products on the exterior surface and
chromecoated parts of the product.
Chlorine will cause rust on such metallic
surfaces.
• Do not use sharp and abrasive tools,
soap, house cleaning materials, deter-
gents, gas, gasoline, varnish and similar
substances to prevent deformation of the
plastic part and removal of prints on the
part. Use warm water and a soft cloth for
cleaning, and then dry it.
EN / 18
EN
DE
FR
IT
Publicité
